Version 06/2007, Rev. 1.15 of 16/09/2011 - sb page 28 of 75
Translation of the original operating manual
5.2 Initial Start-Up
Before the initial start-up, please ensure that your centrifuge is properly set
up and installed (see 4.2 "Installation", page 23).
5.2.1 Switching the Centrifuge ON
• Press the mains power switch on the right side of the front (see Fig. 5.1, page
24).
The centrifuge display then illuminates.
5.2.2 Opening and Closing the Lid
The lid can be opened if the centrifuge is at a standstill and if the lid key is
illuminated.
• Press the lid key in order to open the lid (see 5.3.7 "Activating/Deactivating
the Automatic Lid Opening Function", page 41).
The centrifuge cannot be started if the lid is opened.
To close the lid, press with both hands on the lid so that the lid lock audibly locks
into place.
Do not hold your fingers between the lid and the housing when closing the
lid. Risk of crushing!
Attention!
A flashing lid key indicates that the lid lock has not locked.
To Next Page
Loading...
