Version 06/2007, Rev. 1.15 of 16/09/2011 - sb page 33 of 75
Translation of the original operating manual
• If other data concerning the service life are engraved on the rotor or
bucket, these data shall apply accordingly: For example, a bucket with
the engraving “max cycles = 10,000” has a service life of 10,000 cycles,
and a rotor with the engraving “Exp.Date 02/15” must be scrapped in
Feburary 2015 at the latest (see fig. 5.9)!
Fig. 5.9: Different service life – engraving on the bucket/rotor
Attention!
• Refer to the table of rotors and accessories with a different service
life ( see chapter Fehler! Verweisquelle konnte nicht gefunden werden.
“Appendix”)!
5.2.6 Starting the Centrifuge
The centrifuge is ready for operation when the start key is illuminated.
• Press the start key in order to start a centrifugation run.
5.2.7 Interrupting a Centrifugation Run
• Press the stop key in order to interrupt a centrifugation run.
The centrifugation run will be terminated prematurely.
5.2.7.1 Interrupting a Deceleration Process
• Press the start key during a deceleration process in order to interrupt it and to
restart the centrifuge.
To Next Page
Loading...
