SII LP-1010 - Page 208

12-10
■FTP DATA TYPE
Specifies the initial value of the data transfer type when receiving ftp data.
<Parameter (choice input method)> : Default value
ASCII/BIN/BIN
■SNMP
Specifies the SNMP operation. When the setting is ON, SNMP is enabled.
The SNMP community name can be specified using the Web name.
<Parameter (choice input method)> : Default value
ON/OFF
■SNMP VERSION
Specifies the SNMP version.
<Parameter (choice input method)> : Default value
V1/V2
■TRAP** (** : 01 - 02)
●MANAGER
Specifies the manager IP address to return TRAP.
When the following TRAP conditions are OFF, TRAP does not occur in
this setting.
<Parameter (numerical input method)>
000.000.000.000 to 255.255.255.255
Default value: 000.000.000.000
(TRAP is the same when it is OFF if not registered.)