Operating manual - English REKORD
Copyright Silca 2 007 11
5 MACHINE INSTALLATION AND PREPARATION
The REKORD key-cutting machine can be installed by the purchaser and does not require any special
skills.
However, some checks and preparation for use need to be carried out by the operator.
5.1
Checking for damage
The REKORD ke y-cutting ma chine is solid and compact an d w ill not normally damage if transport,
unpacking and installation have all been carried out according to the instructions in this manual.
However, it is always advisable to check that the machine has not suffered any damage.
5.2
Environmental conditions
To ensure that the best use is made of the REKORD key-cutting machine, certain parameters must be
borne in mind:
-
damp, bad
ly ventilated sites should be avoided.
-
The id
eal conditions for the machine are
:
-
te
mperat
ure:
from 0 to 40°C
-
relative humidity: approx. 60%
5.3
Positioning
Place the key-cutting machine on a horizontal surface, solid enough to take the weight (19 Kg).
To facilitate operation and maintenance, install the machine with a space of at least 200 mm on all
sides
(fig. 6).
Ensure that the machine stands pe rfectly bal anced on the four fee t. Vibration is avoided wh en th e
machine is properly set on the horizontal plane.
ATTENTION:
ensure that the machine voltage is
the same as that of the mains, which must be properly
earthed and provided with a differential switch.
Fig. 6
200 mm
200 mm
200 mm
To Next Page
Loading...
