REKORD Operating manual - English
12 Copyright Silca 2 007
5.4
Removing the blocks
Remove the 2 blocks: on the carriage movement and between cutter and jaw (fig. 7).
Fig. 7
5.5
Separate parts
The separately pa cked pa rts must b e
installed on th e REKORD ke y-cutting
machine by the purchaser,
as follows:
Connection wire
Connect the key-cutting machine p ower
cable to the electricity mains (fig. 8).
Fig. 8
Carriage lever handle
Screw the carriage handle as shown in fig. 9.
Fig. 9
5.6
Connection to the mains
For the safety of the operator and the machine it is important to ensure that the machine is connected
to the proper mains voltage by means of an earthed differential switch.
electricity
supply
power
cable
To Next Page
Loading...
