Operating manual - English Technica EU
8 Copyright Silca 2005
2 TRANSPORT
The
TECHNICA EU
key-cutting machine is easy to transport and is not hazardous to handle.
The packed machine should be carried manually by at least 2 persons.
2.1 Packing
The packing for
TECHNICA EU
is designed to ensure safe transportation and protect the machine and all its parts
.
It comprises a pallet base
(b)
to which the machine is attached, and a cardboard box as a cover
(a) (fig. 6).
The machine is fixed to the base with screwed down brackets to hold it firm during transport and protect it
.
The closed packing is held in place by two straps which hold the cardboard box firmly on the pallet
.
Symbols are printed on the outside of the cardboard box to give instructions and warnings for transportation.
Fig. 6
2.2 Unpacking
To remove the machine from the packing box
:
1)
cut the straps with scissors and remove
.
2)
raise the top part of the cardboard box
.
3) loosen the screws on the front and rear brackets holding the machine on the pallet.
4) use the special spanner to loosen the nuts on the feet by a couple of turns.
5)
remove the metal brackets and tighten the nuts on the feet
.
6)
check the contents of the box, comprising
:
-1
key-cutting machine
- 1 set of documents, including: operating manual, spare parts list and guarantee
- 1 power cable
-1
tools pouch
2.3 Machine handling
When the TECHNICA EU key cutting machine has been unpacked, place it directly on its workbench; this operation
should be carried out by at least two people. Take care to lift the machine firmly holding the base, and no other
part.
a
b
Keep dry This side up Don’t use
Handle with care
To Next Page
Loading...
