Silca Technica EU - Replacing the Fuses; Replacing the Light Bulb

Technica EU Operating manual - English
Copyright Silca 2005 23
Fig. 38
Fig. 39
5.11 Replacing the fuses
The fuses should always be checked with a continuity measuring instrument (tester, ohmeter, multimeter etc.) as a
visible check may not reveal an electrical fault. Fuses must always be replaced with others of the same type (rapid
or delayed) and with the same Amps, as shown in the manual
.
The TECHNICA EU key-cutting machine has 2 fuses placed in the
inlet socket (fig. 40) to protect the key-cutting machine from sudden
changes in voltage or short circuits.
1)
Turn the machine off and unplug it .
2) Remove the fuse board with the aid of a screwdriver.
ATTENTION: fuses must always be replaced with others of the same type
(rapid) and with the same Amps
(5 Amps).
Fig. 40
5.12 Replacing the light bulb
ATTENTION: turn the machine off and unplug it .
1) Loosen the 5 screws (T1) on the lamp shield and
remove.
2) Remove the bulb taking care not to use pointed
utensils for this operation.
3) Fit the new bulb.
4) Replace the lamp shield and tighten the 5 screws
(T1) to secure.
Fig. 41
H1
H3
T1