13
GB
8.4 Interrupt the food
dehydration process
You can interrupt the food dehydration pro-
cess at any time, e.g. to perform a dehydra-
tion test prior to the expiry of the set drying
time.
•
Briefly press the button |
17
once
to in-
terrupt the food dehydration process.
The fan|9 stops. On the display|13 PA
flashes.
• In order to continue the food dehydra-
tion process, briefly press the
button
|
17 again.
8.5 Cancel the food
dehydration process
You can cancel the food dehydration pro-
cess at any time, e. g. if the dehydration of
the food is completed prior to the expiry of
the set time.
1.
Keep the button |
17
pressed until the
fan|9 stops, an audio signal sounds
briefly, and the display|13 shows 00
continuously.
2. After the completion of the food dehy-
dration process, disconnect the mains
plug|4.
8.6 Remove and store the
dehydrated food
• Let the dehydrated food cool well be-
fore removing and packing it.
• Pack the dehydrated food air-tight, e.g.
in glasses with a firmly closing lid or in
plastic bags. You can also vacuum-pack
the dehydrated food.
• Store the dehydrated food protected
from light.
9. Cleaning
Clean the device prior to its first use!
DANGER! Risk of electric
shock!
~ Pull the mains plug|4 out of the wall
socket before you clean the device.
~ The base unit|8, the power cable and
the mains plug|4 must not be immersed
in water or any other liquids.
~ Always make sure that no moisture pen-
etrates the fan|9 during the cleaning
process.
DANGER! Risk of injury
through burning!
~ Allow all the parts to cool down before
cleaning.
WARNING! Risk of material dam-
age!
~ Do not use any astringent or abrasive
cleaning agents.
Clean the device after each use and remove
all food residues.
Lid and food dehydrator trays
The lid|1 and the food dehydrator trays|2
and|3 are dishwasher-safe.
Base unit
• Clean the base unit|8 with a slightly
damp cloth, possibly with some mild de-
tergent.
To Next Page
Loading...
