Silvercrest SRH 5 A1 - Basic Operation; Powering On and Off

■ 10
│
GB
│
IE
│
NI
SRH 5 A1
Handling and operation
Switching the device on/off
NOTE
► The DAB+ station list is automatically created or updated the first time
the device is switched on from standby mode using the
button 2. The
display 1 now shows the message Scanning... DAB. Depending on the
quality of the DAB+ radio reception, this process can take up to several
minutes.
► When switching on the device from standby mode with the
button 2,
the device is in the last selected mode (DAB+, FM, Bluetooth
®
or AUX IN).
♦ Briefly press the button 2 to switch on the device. The device starts
automatically in DAB+ mode the first time it is switched on.
♦ Briefly press the SOURCE/
button
3 to switch between DAB+, FM
radio, Bluetooth
®
or AUX IN mode.
♦ Press the button 2 again to switch off the device and put it into standby
mode.
Adjusting the volume
♦ Turn the VOLUME | ENTER / SCAN dial6 clockwise to increase
the volume.
♦ Turn the VOLUME | ENTER / SCAN dial6 anticlockwise to reduce
the volume.
NOTE
►
The display
1 shows the volume for a few seconds as a bar after turning
the VOLUME |
ENTER / SCAN dial6.
► When the maximum volume is reached, you will hear a short beep.
Radio operation
You can use the radio to receive DAB+ and FM radio stations. You can store up
to 20 preset DAB+ and 20 preset FM radio stations each.
NOTE
► The first time the device is started, it starts in DAB+ mode and the station list
of the available DAB+ radio stations is created automatically.
The display
1 now shows the message Scanning... DAB.