GB
│
IE
│
NI
│
13 ■
SRH 5 A1
FM radio operation (FM)
Automatic scan search (AMS)
♦ This device must be switched on. If necessary, briefly press the button 2 to
switch on the device.
♦ If necessary, briefly press SOURCE/ 3 several times until FM radio
mode and the frequency display in MHz is shown on the display1.
♦ Briefly press the VOLUME | ENTER / SCAN dial6 to start the auto-
matic station scan. The display 1 now shows the message Scanning.... The
station scan stops at the next station with a sufficiently strong signal.
Storing stations automatically
The automatic station scan with station saving scans the entire frequency band
once and automatically saves the FM radio stations found as an FM station list.
♦ Press the VOLUME |
ENTER/SCAN dial 6 for approx. 2 seconds
to start the automatic station scan with station presetting. The display 1
now shows the message Scanning... FM and the number of found stations.
The scan progress is displayed as a progress bar. The FM radio stations
found are automatically stored in the station list on order of increasing
frequency. When the scan is finished, the first station in the station list is
automatically played back.
NOTE
► The automatic station scan replaces the stations already stored in the preset
spaces.
Selecting stations
♦ Press PRESET 5 for about 2 seconds to call up the FM station list.
♦ Press TUNE+ 8 or TUNE− 7 to select an FM radio station from the
station list.
Manual station scan
♦ Press the TUNE+ button 8 for around 2 seconds to jump to the next availa-
ble station with a higher frequency.
♦ Press the TUNE− button
7 for around 2 seconds to jump to the next availa-
ble station with a lower frequency.
NOTE
► The frequency of the station is shown on the display
1 and the speaker9
is switched off during station search.
To Next Page
Loading...
