GB
│
IE
│
NI
│
11 ■
SRH 5 A1
DAB+ radio operation (DAB)
Automatic station scan (AMS)
The automatic station scan with station saving scans the entire frequency band
once and automatically saves the DAB+ radio stations found as a station list.
♦ This device must be switched on. If necessary, briefly press the
button 2
to switch on the device.
♦ If necessary, briefly press SOURCE/
3 several times until the DAB+
radio mode is shown on the display1.
♦ Briefly press the VOLUME |
ENTER/SCAN dial6 to start the
automatic station scan with station presetting. The display 1 now shows
the message Scanning... DAB and the number of found stations. The scan
progress is displayed as a progress bar. The DAB+ radio stations found
are automatically stored in the station list on order of increasing frequency.
When the scan is finished, the first station in the station list is automatically
played back.
NOTE
► An automatic station scan with station saving may overwrite an existing
station list.
Selecting stations
♦ Press the TUNE+8 or TUNE− button 7 to select a DAB+ radio station
from the station list. After approx. 2 seconds, the displayed station is auto-
matically played back.
Saving stations manually
♦ Press the TUNE+8 or TUNE− button7 to select a DAB+ radio station
from the station list.
♦ Press the VOLUME |
ENTER/SCAN dial6 to confirm the selection.
♦ Press the PRESET button5. The display 1 shows the preset space with the
last selected radio station (if radio stations have already been stored). If no
radio stations have yet been stored, the display 1 shows Preset 1 empty.
♦ Press the TUNE+8 or TUNE− button7 to select the desired preset.
♦ Press the VOLUME |
ENTER / SCAN dial6, to store the station in
the selected preset. The preset space of the stored station is shown in the
upper right corner of the display
1 (e.g. P1 for preset 1).
NOTE
► Any previously stored stations will be overwritten.
To Next Page
Loading...
