Silvercrest SRH 5 A1 - Troubleshooting Guide

■ 22
│
GB
│
IE
│
NI
SRH 5 A1
Troubleshooting
If you cannot connect the radio to a compatible Bluetooth
®
playback device,
proceed as follows:
♦ Make sure that the Bluetooth
®
function is activated on the playback
device.
♦ Make sure that the Bluetooth
®
function is activated and the radio is
switched on.
♦ If you use several external playback devices, ensure that any previously
made connection is disconnected. There may be a previously paired play-
back device still within range.
♦ Make sure that the radio is no more than 10 metres from the external
playback device and that no obstacles or electronic devices are placed
between them.
The following table helps to identify and rectify further possible faults:
Fault Possible cause Remedy
There is nothing on
the display
1.
The mains adapter
is not
correctly connected.
Make sure that the mains adapter is
correctly connected with the mains
adapter connection
w and with a
mains socket.
The mains socket is not
supplying any power.
Check the house fuses.
No sound.
The device is not switched
on.
Switch on the device by pressing the
button2.
The volume is set to mini-
mum.
Increase the playback volume with
the VOLUME |
ENTER /
SCAN dial
6.
In AUX mode, the external
playback device is not
turned on.
Switch on the external playback
device.
The external playback
device is muted in AUX
operation.
Unmute the external playback device.
The audio cable is not
correctly connected to the
AUX IN connection
r in
AUX mode.
Make sure that theaudio cable is
correctly connected to the AUX IN
connection
r.
Interference with the
radio reception.
Radio reception is too
weak.
Pull out the telescopic aerial
0 com-
pletely. Try to improve reception by
moving the telescopic aerial
0 or by
moving the radio to another location.