Silvercrest SRH 5 A1 - Alarm Clock Features; Setting Up Alarms

GB
│
IE
│
NI
│
17 ■
SRH 5 A1
Alarm times
The device has two alarms, Alarm1 and Alarm2. For both, you can program
playback of the last radio station you listened to or an alarm tone at a specific
time.
Setting the alarm
♦ Press INFO/MENU 4 for about 2 seconds to call up the settings menu.
Alarms is shown as the first menu option on the display 1.
♦ Press the VOLUME | ENTER/SCAN dial6 to confirm the selection.
♦ Press the TUNE+
8 or TUNE− button 7 select either Alarm1 or Alarm2.
♦ Press the VOLUME | ENTER/SCAN dial6 to confirm the selection.
The display 1 now shows the message Alarm detail.
♦ Push the VOLUME | ENTER / SCAN dial6 to set the alarm to On.
♦ Press the TUNE+ button
8 to go next to the setting of the alarm time.
♦ Press the VOLUME | ENTER/SCAN dial6 to set the alarm time.
Set alarm time appears on the display1 and the hour display flashes.
♦ Press the TUNE+ 8 or TUNE− button7 to set the hours.
♦ Press the VOLUME |
ENTER/SCAN dial6 to confirm the entry.
The minutes flash on the display 1.
♦ Press the TUNE+ 8 or TUNE− button7 to set the minutes.
♦ Press the VOLUME | ENTER/SCAN dial6 to confirm the entry.
♦ Next select the menu item Days to select whether the alarm should be
activated daily, only once, only on weekdays or only on weekends. Press
the VOLUME |
ENTER / SCAN dial6 and then the TUNE+8 or
TUNE− button7 to make the appropriate setting.
♦ Press the VOLUME | ENTER/SCAN dial6 to confirm the selection.
♦ Next select the alarm type under the menu item Mode. You can choose
between the last DAB+ or FM radio station (DAB/FM) or an alarm tone
(Buzzer). Press the VOLUME |
ENTER / SCAN dial6 and then the
TUNE+8 or TUNE− button7 to make the appropriate setting.
♦ Press the VOLUME | ENTER/SCAN dial6 to confirm the selection.
♦ Next, select the volume of the alarm under the menu item Volume. Press
the VOLUME | ENTER / SCAN dial6 and then the TUNE+8 or
TUNE− button7 to set the alarm volume.
♦ Press the VOLUME |
ENTER/SCAN dial6 to confirm the selection.
♦ Next, save your settings under the menu option Save by pressing the
VOLUME | ENTER / SCAN dial6. The alarm is now activated.