Silvercrest SRH 5 A1 - External Audio Input; Connecting via AUX IN; Accessing Settings Menu

■ 16
│
GB
│
IE
│
NI
SRH 5 A1
Connecting external playback devices (AUX IN mode)
In AUX IN mode, you can connect external playback devices such as a smart-
phone or an MP3 player to use them as the playback source for the radio.
NOTE
► Switch the radio and the external playback device off before connecting
them. Note also the operating instructions for the device that you want to
connect to the radio.
♦ Connect the external playback device to the AUX IN connection
r of the
radio using the supplied AUX cable.
♦ Briefly press the button2 to switch on the radio.
♦ If necessary, briefly press the SOURCE/ button 3 several times until
Auxiliary Input appears on the display
1.
♦ Turn on the external playback device and start playback.
♦ Afterwards, set the desired volume using the VOLUME | ENTER /
SCAN dial6 on the radio. Alternatively, you can increase the volume on
the external playback device.
♦ To stop AUX operation, turn off the radio and the external playback device.
Remove the AUX cable from the AUX IN connection r of the radio. Alter-
natively, you can press SOURCE/
3 to switch directly from AUX IN
mode to radio mode or Bluetooth
®
mode.
Connecting headphones
♦ Turn the VOLUME | ENTER / SCAN dial6 anticlockwise to the
lowest volume level.
♦ Insert the jack plug of the headphones into the headphone socket
e
on the rear of the device. Sound playback now takes place only via the
connected headphones.
♦ Set the desired volume using the VOLUME | ENTER / SCAN dial6.
Settings menu
NOTE
► The settings menu can be called up during operation as well as in standby
mode.
► If no setting is made in the setup menu for more than 7 seconds, the setup
menu is exited.
♦ During normal operation or standby, press INFO/MENU 4 for about
2 seconds until System appears on the display 1 .