SETUP AND OPERATION
Starting and Shutting down the Projector
Connect the power cord to the
projector. Connect the other end to
a wall outlet.
The POWER LED on the
projector light.
Turn on the connected devices.
Ensure the POWER LED not a
flashing. Then press the POWER
button to turn on the projector.
The projector splash screen displays
and connected devices are
detected.
If more than one input device is
connected, press the SOURCE
button and use ▲▼ to scroll among
devices.
(Component is supported through
the RGB to COMPONENT
ADAPTER.)
x PC: Analog RGB
x HDMI 1 / HDMI 2: High-Definition Multimedia
Interface
x COMPONENT: DVD input YCbCr/ YPbPr, or HDTV
input YPbPr
x VIDEO: Traditional composite video
To Next Page
Loading...
