Sim2 SuperCube - Resetting the Lamp

– 37 –
English
Resetting the Lamp
After replacing the lamp, you should reset the lamp hour counter to zero. Refer to the following:
1.
Press the MENU button to open
the OSD menu.
2.
Press the cursor ◄► button to
move to the SETUP : Advanced
menu. Press the cursor button to
move down to Lamp and press
enter.
3.
Press the cursor ▼▲ button to
move down to Reset Lamp
Timer.
4.
Press the ◄► buttons to adjust
the settings.
5.
Press the MENU button to get
back to SETUP : Advanced.