Important Safety Instructions (continued)
PLEASE READ ALL INSTRUCTIONS AND PRECAUTIONS CAREFULLY
AND COMPLETELY BEFORE OPERATING YOUR MOON 240i
1. ALWAYS disconnect your entire system from the AC mains
before connecting or disconnecting any cables, or when
cleaning any component. To completely disconnect this
apparatus from the AC mains, disconnect the power supply
cord plug from the AC receptacle.
2. The MOON 240i must be terminated with a three-
conductor AC mains power cord which includes an earth
ground connection. To prevent shock hazard, all three
connections must ALWAYS be used. Connect the MOON
240i only to an AC source of the proper voltage; Both the
shipping box and rear panel serial number label will indicate
the correct voltage. Use of any other voltage will likely
damage the unit and void the warranty
3. AC extension cords are NOT recommended for use with
this product. The mains plug of the power supply cord shall
remain readily accessible.
4. NEVER use flammable or combustible chemicals for cleaning
audio components.
5. NEVER operate the MOON 240i with any covers
removed. There are no user-serviceable parts inside.
An open unit, especially if it is still connected to an AC source,
presents a potentially lethal shock hazard. Refer all questions
to authorized service personnel only.
6. NEVER wet the inside of the MOON 240i with any liquid. If a
liquid substance does enter your MOON 240i, immediately
disconnect it from the AC mains and take it to your MOON
dealer for a complete check-up.
7. NEVER spill or pour liquids directly onto the MOON 240i.
8. NEVER block air flow through ventilation slots or heatsinks.
9. NEVER bypass any fuse.
10. NEVER replace any fuse with a value or type other
than those specified
11. NEVER attempt to repair the MOON 240i. If a problem occurs
contact your MOON dealer.
12. NEVER expose the MOON 240i to extremely high
or low temperatures.
13. NEVER operate the MOON 240i in an explosive atmosphere.
14. ALWAYS keep electrical equipment out of reach of children.
15. ALWAYS unplug sensitive electronic equipment during
lightning storms.
16. WARNING: Do not expose batteries or battery pack
to excessive heat such as sunshine, or fire or the like.
The lightning flash with the arrowhead symbol, within an equilateral triangle, is intended to alert the user
to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the literature accompanying the appliance
Marking by the “CE” symbol (shown left) indicates compliance of this device with the EMC
(Electromagnetic Compatibility) and LVD (Low Voltage Directive) standards of the European Community
To Next Page
Loading...
