Sime FORMAT DGT 30e User Manual

33
– AUXILIARY SENSOR ERROR
ALARM 10

(Ensure that PAR 2 is set correctly).
– MODULATOR ERROR
ALARM 11
 Themodulatorisnotconnected.
 Ifduringfunctioningtheboilerdetects
zerocurrenttothemodulator,thedi-
splaywillshowanomaly“AL 11”.
 The boiler will function at minimum
power and the anomaly will be de-
activated when the modulator is re-
connected or when the burner stops
working.
– CONFIGURATION ERROR
ALARM 12
 Anomaly in the SEALED/OPENconfigu-
ration.Theremaybeaconflictbetween
thevaluessetbytheinstallerforPAR1
andtheself-detectioncarriedoutbythe
cardcausestheactivationofthealarm:
the boiler will not function and the di-
splaywillshowanomaly“AL 12”.
 ResetPAR 1 tode-activatethealarm
orcheckthepressureswitch/combu-
stion productthermostatand relative
connection.
– HEATING PROBE POSITIONING
ERROR SM1/SM2
ALARM 16 (fig.4/d)
 Iftheprobedoesnotdetectatempe-
rature increase after burner ignition,
theburnerswitchesoffafter10secon-
ds, the display shows anomaly AL 16
andthe4greenLEDstayson.
 Iftheanomalyoccursthreetimeswi-
thin24htheboilerlockout,thedisplay
continuestoshowerrorAL16andthe
redLEDswitcheson.

Press 
1
2
3
4
onthecontrolpaneltore-start
theboiler.
– SENSOR ALIGNMENT ERROR
ALARM 17
 When the two sensitive elements of
theheatingprobe(SM1/SM2)differto
eachotherbymorethan16°Ctheboi-
ler does not function and the display
showserror AL17.
Replacethehea-
tingprobe(SM1/SM2)torestoreope-
ration.
1
2
3
4
Fig.4/d

Sime FORMAT DGT 30e Specifications

General

Brand	Sime
Model	FORMAT DGT 30e
Category	Boiler
Language	English