EasyManua.ls Logo

Sime FORMAT DGT 30e - Anomalies and Solutions; Gas Conversion Procedure

Sime FORMAT DGT 30e
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
ANOMALIES AND SOLUTIONS
Whenthereisafunctioning anomaly,
thedisplaycontrolsshowsa red led.
Descriptionsoftheanomalieswiththe
relative alarms and solutions are gi-
venbelow:
– AL 01 (fig.4)
Pressthekey
1
2
3
4
ofthecontrolsto
re-starttheboiler.
If the anomaly persists, call a qua-
lified technical personnell.
– AL 02 (fig.4/a)
Ifthewaterpressuredetectedislo-
werthan0.5bar,theboilerwillstop
andthedisplaywillshow“AL02”.
Bring the pressure back to normal
bymeans of the charging system,
until the pressure indicated by the
hydrometer is between 1 and 1.2
bars.
If it is necessary to repeat the sy-
stem loading procedure, it is advi-
sable to contact qualified technical
personnel to check the seal of the
heating system (to check whether
there are any leaks).
– AL 04
Call a qualified technical person-
nel.
– AL 05
Call a qualified technical person-
nel.
– AL 06 (fig.4/b)
Pressthekey
1
2
3
4
ofthecontrolsto
re-starttheboiler.
If the anomaly persists, call a qua-
lified technical personnel.
– AL 07 (fig.4/c)
Pressthekey
1
2
3
4
ofthecontrolsto
re-starttheboiler.
If the anomaly persists, call a qua-
lified technical personnel.
– AL 08
Call a qualified technical person-
nel.
– AL 10
Call a qualified technical person-
nel.
– AL 11
Call a qualified technical person-
nel.
– AL 12
Call a qualified technical person-
nel.
– AL 16 (fig.4/d)
Pressthekey
1
2
3
4
ofthecontrolsto
re-starttheboiler.
If the anomaly persists, call a qua-
lified technical personnel.
– AL 17
Call a qualified technical person-
nel.
GAS CONVERSION
Ifitisnecessarytochangetoadiffe-
rent type of gas, request assistance
only from authorised technical per-
sonnel.
MAINTENANCE
Please refer to the maintenance
schedule in Section 6 of this manual.
The boiler is supplied with an electri-
cal supply cable.
If this is damaged in any way it should
be replaced only by a new cable from
Hunt Heating and installed by a qua-
lified technician.
DEFINITION: A qualified technical
personnel. A person who is trained
and licenced by law to install, make
changes to this boiler.
The end user is wise to request the
personnel’s licence before any work
is done.
1
2
3
4
Fig.4
Fig.4/a
04
13
2
bar
1
2
3
4
Fig.4/b
1
2
3
4
Fig.4/c
1
2
3
4
Fig.4/d

Table of Contents

Other manuals for Sime FORMAT DGT 30e

Related product manuals