Simonelli MUSICA - Page 11


At the end of installation, the device is
switched on and taken to rated operating
conditions, leaving it in a state in which it is
“ready for operation”.
The device is then switched off and the whole
hydraulic circuit is bled of the first lot of water
in order to remove any initial impurities.
The device is then refilled and taken to rated
operating conditions.
After reaching the “ready for operation” con-
dition, the following dispensing operations
are carried out:
- 100% of the coffee circuit through the cof-
fee dispenser (for more than one dispenser,
this is divided equally);
- 100% of the hot water circuit through the
water dispenser (for more than one dis-
penser, this is divided equally);
- opening of each steam outlet for 1 minute.
At the end of installation, it is good practice to
draw up a report of the operations.
WARNING
Before using the machine, read this manual in its
entirety or, at the very least, read the safety and set
up instructions.

There are some basic rules for the use of any
electrical appliance.
In particular:
  •nevertouchtheunitwithwethandsorfeet;
  •neverusetheunitwithbarefeet;
  •never use extension cords in areas
equipped with baths or showers;
  •never pull on the power supply cord to
unplug the unit;
  •never leave the unit exposed to atmos-
pheric agents (rain, direct sunlight, etc..);
  •neverletchildren,unauthorizedpersonnel
or anyone who has not read this manual
operate the unit.

Before performing any sort of maintenance,
the authorized technician must turn off the
unit and unplug it from the mains.

Before cleaning the unit set it in a state of "0"
energy: that is, "MACHINE SWITCHED OFF
AND UNPLUGGED". Follow the instructions
given in this manual carefully.

For cleaning and maintenance please refer to
chapter 7.

In case of breakdown or poor function, turn
off the unit. Never tamper with the unit.
Contact only professionally qualified person-
nel.
Only the manufacturer or an authorized ser-
vice center can make repairs and only using
original spare parts.
No compliance with the above can compro-
mise machine safety.

Upon installation, the qualified electrician
must arrange for an omnipolar switch, as
called for by the safety regulations in force
and which performs a complete disconnec-
tion under the conditions of over tension
category III. When open, the contacts must be
3 mm or more apart.

To prevent dangerous overheating, it is advis-
able to fully extend the power supply cord.

Never block the intake and/or heat dissipation
grills, in particular those for the cup warmer.
Ed. 01 of 12/2015
1.5
SERVICE MANUAL
Fig. 5
Fig. 6
Fig. 7