Simonelli MUSICA - Heater Draining

WARNING
Every time you work directly.
With the heater it is important to ensure that
the internal pressure is zero. Completely
remove the water inside for operations that
require it.
To empty the heater proceed as follows:
1 Turn off the machine and let out all the steam
by opening fully the steam outlets to lower
the temperature quickly.
2 Remove covers:
 • Sidepanels;
 • Rearpanel;
 • Frontpanel.
WARNING
Before carrying out the heater emptying pro-
cedure, remove water inlet sources inside the
waterline:
• Waterline version: close the water inlet
tap and disconnect the pipe.
•
Tank version: remove the tank from its seat.
These operations are necessary to avoid any
water leakage inside the machine that may
cause damage.
5.1 EMPTYING THE HEATER
3 Place the machine on the right side to pre-
vent water leakage and loosen the drain nut
“A” using a 13 mm wrench.
DANGER
Before proceeding with the operations
described in the chapter make sure that the
machine is turned off and unplugged from the
mains. Discharge any residual pressure pres-
ent in the steam heater.
DANGER
Fig. 57
Ed. 01 of 12/2015
5.2
SERvIcE MANuAl
Fig. 59
Fig. 58
A
Fig. 60