Simonelli MUSICA - Steam Nozzle Maintenance

6 Check the spring is working properly and
that the inner cylinder is clean.
Replace the valve completely, if there is
nothing visible that affects its use.
6.4.1 DiSaSSeMBlY OF HOT wa-
Ter nOzzle
To reassemble the hot water nozzle, proceed as
follows:
1 Remove the front panel (see paragraph 3.5).
2 Loose the locking nut “A” using a 22 mm
wrench and take the nozzle out.
WHEN TO INTERVENE
Problems related to the steam nozzle are:
• Continuouslossofsteam.
• Waterdrippingfromthesteamnozzle.
• Delayedclosure.
• Steamlevertooloose.
DANGER
Before proceeding with the operations
described in the chapter make sure that the
machine is turned off and unplugged from the
mains. Discharge any residual pressure pres-
ent in the steam heater.
DANGER
Fig. 102
Ed. 01 of 12/2015
6.10
Service Manual
Fig. 99
A
Fig. 100
6.5 STeaM nOzzle
The steam nozzle is composed of a piston actu-
ated by the knob, which presses on a nut with
spring return. By pressing against the spring it
creates space for the steam to pass.
We suggest to replace the seals that keep the
piston perfectly aligned, every 4-6 months. Every
year it is advisable to replace the nut to prevent
the gasket that insulates the steam from drying
and letting seam pass. Since these parts must
be changed, we suggest replacing all the seals
simultaneously.
Fig. 101