2.1.5 PrOceDure OF FirST
inSTallaTiOn
Before installing the unit, carefully read the safety
instructions at the beginning of this manual.
Arrange the accessories as follows:
1 Insert the ring (3) inside the seat of the filter
holder.
2 Insert one of the two filters (1 or 2).
Tank Model
3 Open the hatch (14) and take out the reser-
voir (1).
4 Especially the first time, wash the reservoir
with soap and water.
5 Fill the reservoir with water and make certain
that the outside of the reservoir is dry.
6 Return the reservoir (1) to its housing and
close the hatch (14).
Model for Direct connection to the water
mains.
When connecting the mains water supply,
always use a new pipe, suitable for this pur-
pose.
3 Remove the tube from the hatch (14) on the
top part of the machine.
4 Connect the end of the pipe to the fitting on
the base of the machine.
5 Connect the other end of the tube with the
1/8” union to the mains water supply.
6 Make certain that the water drain tank (7) has
been inserted.
WARNING
To Next Page
Loading...
