Simonelli MUSICA - Surface; Removal of Water Tank

NOTE
Before proceeding with the removal of the
panels it is advisable to clean and free up
enough space where the machine parts will
rest so that they are not be unintentionally
damaged.
DANGER
DANGER
Before proceeding with the operations
described in the chapter make sure that the
machine is turned off and unplugged from the
mains. Discharge any residual pressure pres-
ent in the heater.
Use gloves to protect against sharp or hot
surfaces that you can bump against involun-
tarily during operations.
3.1 reMOval OF WaTer TanK
To remove machine covers, take out the water
tank first:
NOTE
This operation is necessary only for the ver-
sion with tank.
To remove the tank from its seat, proceed as fol-
lows:
1 Lift the water tank cap.
Ed. 01 of 12/2015
3.2
Service Manual
CUTTING
AND
HOT
SURFACES
Fig. 22
DANGER
Fig. 23
Fig. 24