Simonelli MUSICA - Page 57

4 Loose the steam pipe fitting of the nozzle by
means of a 20 mm wrench, by levering the
locking nut with a 23 mm wrench, as shown
on the figure.
5 Unscrew the locking nut of the steam nozzle
with a 23 mm wrench, by levering the steam
valve block with a 22 mm wrench.
3 Loose the steam nozzle by means of the nut
“A” using a 22 mm wrench, by levering the
nozzle locking nut with a 23 mm wrench, as
shown on the figure.
If there is a loss of vapor or condensation, it is
necessary to:
1 Turn the machine off, let out all the steam
until there is no pressure in the heater.
2 Remove the left side panel and the front one.
A
Fig. 104
Fig. 105
Fig. 106
Fig. 103
Ed. 01 of 12/2015
6.11
Service Manual