12
CAUTION
Failure to clean properly will cause the injection system to become clogged
and inoperable.
CAUTION
Never use:
• Bleach, chlorine products and other corrosive chemicals
• Liquids containing solvents (i.e., paint thinners, gasoline, oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage the surface being cleaned.
Rinse with clean water under high-pressure. On a vertical surface, rinse from the bot-
tom up, then rinse from the top down to avoid streaking. Hold nozzle 6–8” (15-20 cm)
from the work surface at a 45° angle.
When you have finished using the detergent injection system, remove detergent suction
tube from bottle and insert into 1 gallon (5 L) of fresh water. Siphon water at low-pres-
sure for one minute so that all detergent is ushed through system. Remove detergent
bottle and rinse it until it is thoroughly cleaned.
5
6
OPERATING INSTRUCTIONS
To Next Page
Loading...
