15
CLEANING AND USER MAINTENANCE
Connections
Connections on pressure washer hoses; gun and spray wand should be cleaned regularly
and lubricated with non-water soluble grease.
Air Vents
The air vents located on the back of the unit must be kept clean and free of any
obstructions to ensure proper air-cooling of the motor during operation.
Adjustable Nozzle Only
Clogging of the nozzle causes the pump
pressure to be too high and cleaning is
immediately required. You can clean the
nozzle by carefully inserting a thin, sharp
instrument (i.e. paperclip) into the tip to rid
it of deposits.
For the adjustable nozzle, you can also
lubricate the nozzle collar (high-pressure/
low-pressure) by using non-water soluble
grease regularly.
Water Filter Screen
The pressure washer is equipped with a
water inlet screen to protect the pump. If
the screen is not kept clean, the ow of wa-
ter to the pressure washer will be restricted
and the pump may be damaged.
1. To clean inner water screen, remove
quick-connector and remove the filter
screen from the pump inlet.
2. Rinse screen until it is free of debris
and blockage.
3. Replace screen and quick-connector im-
mediately to prevent any foreign matter
from entering the pump.
To Next Page
Loading...
