11
OPERATING INSTRUCTIONS
Working with detergent ensures a quick soaking of the dirt, and allows the high-pressure
water to penetrate and remove the dirt more effectively. Always spray detergent on a dry
surface, do not pre-soak area. Wetting the surface first dilutes the detergent and reduces
its cleaning ability.
To apply detergents you must be operating at low-pressure. This provides a gentle applica-
tion of detergent, with the pressure equivalent to a lowest garden hose. The high-pressure
setting is used for cleaning; you cannot apply detergents when working at high-pressure.
Always test detergent in an inconspicuous area before use.
CAUTION
Only use cleaning detergents recommended for this pressure washer.
WORKING WITH DETERGENTS
1
3
2
4
Install the adjustable wand. Set the adjust-
able nozzle to the low-pressure setting by
sliding the nozzle collar out. The nozzle
must be set in the low-pressure position to
apply detergents.
Turn on the pressure washer. Pull trigger to operate unit. The liquid detergent will automati-
cally mix with water and be discharged through nozzle. Apply detergent to a DRY work
surface, from bottom to top.
Attach detergent suction tube onto de-
tergent lid. Fill the detergent bottle with
detergent. Screw the lid onto the detergent
bottle and attach bottle to the pressure
washer. Note: You can adjust amount of
detergent by moving the detergent lid tab
between – and +.
Allow detergent to remain on the surface for a short time before rinsing. Do not allow
detergent to dry on surface.
CAUTION
Damage may occur to painted surface if chemical is allowed to dry on surface. Wash
and rinse a small section at a time. Avoid working on hot surfaces or in direct sunlight.
To Next Page
Loading...
