SYSTEM POWER-UP (continued)
Note: If system shows continuous alarm, check for activate initiating devices (construction dust in a smoke detector
can cause false alarms).
4. At battery harness, connect one end of the white jumper to positive terminal of one battery and other end to
negative terminal of other battery (Fig. 25).
l
The POWER TROUBLE and SYSTEM TROUBLE LEDs go out and the tone device sounds.
5. Set the TROUBLE SILENCE switch back to the NORMAL (up) position.
6. To test the system for proper operation, perform the procedure on Page 28 (How to Test the System).
FIGURE 25
22