Simplex 4100 Series - List of System Faults - Non-Networked

Page 35 of 60
35 of 60
of 60
of
5 of 1
60
4.1 Recall System Faults
4.1.1 Function
The Recall System Faults function allows viewing on the LCD the current causes of a "SYSTEM
FAULT" indication. It also displays the status of any RZDU (Remote Zone Display Unit) that has an
off-normal condition, including those which do not cause System Fault
4.1.2 Operating Sequence
For both networked and non-networked systems, from the base display, press:
OR
If there are no system faults, a brief message is displayed saying so, and the LCD reverts to the base
display.
If a system fault exists, the LCD will display it. To view the next fault, press:
To view the previous fault, press: