Simplex 4100 Operation

1-5
The Version 9.X TrueAlert modifications have the following effects on the
4100/4020 Operator Interface:
• TrueAlert appliances are visible as points with custom labels. However,
appliances cannot be individually controlled and there is no “ON/OFF” status.
• TrueAlert appliances only have trouble status associated with them.
• TrueAlert channels are visible and behave in a similar fashion to MAPNET
channels in terms of status reporting.
• Turning on all of the LEDs on a TrueAlert Controller is accomplished
through the TrueAlert appliance address.
• VNACs are visible as signal circuits. They appear after the last conventional
signal circuit in the FACP.
• VNACs only have on/off, disable, and manual override status associated
with them.
Version 9.X System Description,
Continued
Effects on the Operator
Interface
firealarmresources.com

Simplex 4100 Specifications

General

Type	Fire Alarm Control Panel
Manufacturer	Simplex
Model	4100
Network Capability	Yes
Addressable	Yes
Power Supply	120/240 VAC, 50/60 Hz
Display	LCD
Annunciator Support	Yes
Battery Backup	Yes
Releasing Capability	Yes
Max Devices	Depends on configuration
Max Notification Appliance Circuits (NAC)	Varies with configuration
Max Releasing Circuits	Varies with configuration
Max Remote Annunciators	Varies with configuration
Communication Ports	Multiple
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH, non-condensing
NAC Outputs	4 (expandable)
Networking	Yes