Simplex 4100 - How to Enable a VNAC

2-6
Note: To perform this procedure, you must be at the correct Access
Level or higher.
Use the following procedure to enable a VNAC:
1. Press <TBL ACK> until the VNAC signal number is displayed.
VIRTUAL NAC 10 – ALL A/V DEVICES
SIGNAL CIRCUIT DISABLE TROUBLE
2. Press ENABLE.
PRESS <ENTER> TO ENABLE
SIGNAL CIRCUIT: SIG12
3. Press ENTER on the ENTRY keypad. The display acknowledges the
action.
ACTION TAKEN
The trouble count should decrease by one.
4. After a few seconds, a message appears. (For this example, the signal circuit
is “OFF.”)
VIRTUAL NAC 10 – ALL A/V DEVICES
SIGNAL CIRCUIT OFF
Enable the remaining VNAC in a similar manner.
Handling Disabled Conditions,
Continued
How to Enable a VNAC
firealarmresources.com