2-1
This chapter shows how to handle abnormal system operations for a typical
4100/4020 FACP running Version 9.X firmware. Your system operation may
vary due to custom programming and local code requirements.
This chapter discusses the topics listed in the following table. Refer to the page
number listed after the topic for information on that topic.
Topic See Page #
Handling Abnormal Conditions 2-2
Read the Display 2-2
How to Identify a TrueAlert appliance 2-2
How to Identify a Version Mismatch Condition 2-3
Handling Disabled Conditions 2-5
How to Disable a VNAC 2-5
How to Enable a VNAC 2-6
Chapter 2
System Operations
Introduction
In this Chapter
To Next Page
Loading...
