Simplex 4100 Operation

3-8
Notes:
1. In order for the TrueAlert Appliance WalkTest to work properly,
only one VNAC is allowed per WalkTest group.
2. The TrueAlert strobes will not flash during this test.
The TrueAlert Addressable Controller will fully support the Non-Voice Simplex
WalkTest. Use the following procedure to initiate the TrueAlert WalkTest.
1. Put the 4100/4020 Operator Interface Panel into WalkTest and verify the
WalkTest trouble reports.
2. Initiate a monitor point from each WalkTest group and verify that the
correct code is generated on the appropriate appliance.
BLANK
BLANK PAGE
TrueAlert Appliance WalkTest
Procedure
firealarmresources.com

Simplex 4100 Specifications

General

Type	Fire Alarm Control Panel
Manufacturer	Simplex
Model	4100
Network Capability	Yes
Addressable	Yes
Power Supply	120/240 VAC, 50/60 Hz
Display	LCD
Annunciator Support	Yes
Battery Backup	Yes
Releasing Capability	Yes
Max Devices	Depends on configuration
Max Notification Appliance Circuits (NAC)	Varies with configuration
Max Releasing Circuits	Varies with configuration
Max Remote Annunciators	Varies with configuration
Communication Ports	Multiple
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH, non-condensing
NAC Outputs	4 (expandable)
Networking	Yes