visit www.simplisafe.com or call 1-888-95-SIMPLI (957-4675) for additional assistance
3
Install your Keypads
• Remove the battery activation strip.
• Adhesive tape has already been installed on the back of
the Keypad – just peel and stick. If you make a mistake,
see “How do I move a sensor?” on page 18.
• Adhere the Keypad to the wall by your main entrance.
Helpful Information about your Keypad
Your alarm system has 3
modes: Away, Home, and
O. Turn your alarm on by
putting it in Away or Home
Mode. Turn your alarm o by
putting it in O Mode.
Before applying the adhesive
tape make sure the surface is
clean and dry.
For the most reliable wireless
connection, install the Keypad
10-100 ft from the Base Station.
Your default PIN is 1234. We’ll help you change that when
we personalize your system in just a few minutes.
Tip:
Tip:
Tip:
Mode buttons
Press on the left, right,
bottom and top of the screen
to navigate the menu.
Tip:
To Next Page
Loading...
