AUTO mode (Heading hold)
In AUTO mode the autopilot issues rudder commands required to steer the vessel
automatically on a set heading. In this mode the autopilot does not compensate for any
drifting caused by current and/or wind (A).
• Switch to AUTO mode by pressing the AUTO key. Repress the key to highlight the Auto
option in the pop-up menu
When the mode is activated, the autopilot selects the current boat heading as the set
heading.
Changing set heading in AUTO mode
You adjust the set heading by turning the rotary knob or by pressing the port or starboard
keys.
An immediate heading change takes place. The new heading is maintained until a new
heading is set.
Heading capture
When the vessel is turning in AUTO mode, an instant re-press on the AUTO key or the rotary
knob activates the heading capture function. This will automatically cancel the turn, and the
vessel will continue on the heading read from the compass the very moment you pressed
the AUTO key or the rotary knob.
Temporary heading changes
If you need to avoid an obstacle when in AUTO mode, you can press the STBY key and
power steer or use the helm until the obstacle is passed.
If you re-press the AUTO key within 3 minutes you can select to continue on previous set
heading. If you don’t respond within 3 seconds the menu will disappear, and the autopilot
will go to AUTO mode with current heading as set heading.
Quick menu in AUTO mode
From the Quick menu in AUTO mode you can change rudder parameters and set manual
speed.
22
Autopilot modes | AP70 MK2 Operator Manual
To Next Page
Loading...
Need help?
General
