Simrad GO7 Installation Manual

Rudder drive setup
The rudder drive setup controls how the autopilot computer
controls the steering system.
Drive voltage
Voltage specified for your drive unit. The Drive unit voltage setting
does not apply when the system operates solenoids on a
continuous running pump/steering gear. Hence, the output voltage
to the solenoids will be the same as the input voltage.
Refer to the drive unit table in the AC12N/AC42N Installation
manual or to your drive unit documentation for information.
Warning: Selection of improper voltage level for your
drive unit may damage both the drive unit and the
AC12N/AC42N even if the protection circuits are
activated.
Drive engage
Clutch
This is the default setting and it allows you to steer the boat with
the helm or wheel when in STBY mode (FU and NFU modes) as well
as in all auto steering modes.
Auto
This option is typically used to switch between two rudder speeds
on a continuous running pump, used when different rudder speeds
are required for automatic and Follow-up/Non-Follow-up steering.
Software Setup | GO7 Installation Manual
27

Simrad GO7 Specifications

General

Resolution	800 x 480 pixels
Touchscreen	Yes
Networking	NMEA 2000
Bluetooth	Yes
Chartplotter	Yes
Display Size	7 inch
GPS Type	Internal
Wireless Connectivity	Wi-Fi
Chart Compatibility	C-MAP, Navionics
Display Type	TFT LCD
SD Card Slots	1
Sonar Compatibility	CHIRP
Radar Compatibility	Yes
Operating Temperature	-15°C to 55°C
Sonar	Broadband, CHIRP, DownScan, SideScan (with compatible transducer)