• User data file version 5: Use with current units (NSO evo2,
NSS evo2, NSS, NSO, NSE, Zeus, Zeus Touch, HDS Gen2, HDS
Gen2 Touch, HDS Gen3). Offers most detail.
• User data file version 4: Use with current units (NSO evo2,
NSS evo2, NSS, NSO, NSE, Zeus, Zeus Touch, HDS Gen2, HDS
Gen2 Touch, HDS Gen3).
• User data file version 3 (with depth): Use with legacy GPS
chartplotters.
• User data file version 2 (no depth): Use with legacy GPS
chartplotters.
• GPX (GPS Exchange, no depth): Use with some other
manufacturers’ GPS products, and PC applications.
After you select the file type, select Export and destination memory
card. The receiving GPS/PC will typically need to be set to allow
import of Waypoints.
Settings database export
Select Setting database to export the Settings database, or export
CZone configuration (CZone installation dependent). Choose the
desired option and select the memory card destination.
Importing a database
Later, if the GO7 has been restored to factory defaults or user data is
accidentally deleted, return to the files page, select the backed up
file, and then Import. View file details for creation date.
Software upgrades
The update file must be loaded to the root directory of the memory
card.
The update may be initiated at boot up: insert the memory card into
the card reader before turning the unit on, boot the unit, and follow
the on-screen instructions.
Alternatively, in the Files menu, locate the update file on the
memory card inserted in the card reader and select Upgrade,
followed by This Display. Accept the prompt to reboot the unit,
and wait a few moments as the unit restarts. Do not remove the
memory card or repower the GO7 until the process is completed
(this typically takes no more than a couple of minutes).
44
Software Setup | GO7 Installation Manual
To Next Page
Loading...
Need help?
General
