Software upgrade of remote device
It is possible to run an update remotely from one unit and apply it
to another, provided they are on the NMEA network. This is only
possible for units without a card slot.
Remote updating is similar to updating a local unit; select the file on
the memory card and select the Upgrade option, followed by
Remote Upgrade. Follow the onscreen options.
NMEA 2000 device upgrades
The update file must be loaded to the root directory of a memory
card. inserted in the card reader.
To update NMEA 2000 devices select the Upgrade option
presented when the file is highlighted. A list should appear
displaying any compatible devices the update file applies to. In
most cases this will be a single device. Select the device and initiate
the upgrade. Do not interrupt the upgrade process.
Ú
Note: If no device is shown, check that the device to be
updated has power, and run any outstanding updates for
the unit first.
NMEA 2000 setup
Receive waypoint
Select this option to allow another device capable of creating and
exporting waypoints via NMEA 2000 to transfer directly to the GO7.
Software Setup | GO7 Installation Manual
45
To Next Page
Loading...
Need help?
General
