assigned in the Device Name setting. If the GO7 does not
appear, follow the on screen instructions to manually find the
device.
5. Select the graphic icon of the GO7. The GO7 displays a prompt
similar to the following:
6. Select Yes for one-time connection, or Always if device is to be
remembered for regular connection. This setting can be
changed later if required.
Ú
Note: The internal wireless module only supports GoFree
connection to itself. Other units connected on the network
are not visible.
Remote controllers
When a wireless device is connected, it should appear in the
Remote controllers list. Selecting Always allow means the device
can automatically connect without needing a password each time.
This menu also allows disconnection of devices that no longer
require access.
Wireless device
This page shows the internal wireless module and its IP and channel
number.
Selecting the device provides additional detail. The Network Name
and the Network Key can be edited for security, and Channel can be
changed if the connection to the unit is compromised due to
interference by another RF device transmitting in the same
frequency band. Restore defaults returns the unit to factory settings.
Software Setup | GO7 Installation Manual
41
To Next Page
Loading...
Need help?
General
