MARIS ECDIS900 Installation Manual
SERIAL INTERFACE, SIS4000-MK2
HARDWARE NOTES
SIS4000-Mk2 is a network-based module. All channels are configured for RS422.
Channel 1 to 6 is input only, Baud rates 4800 or 9600, 8n1.
Channel 7 and 8 is input/output, Baud rates 1200 to 115200, 8n1.
The tables that follow are for general cargo ships. Seismic vessels and other special purpose
ships will most likely be different.
The same goes for sensors transmitting on an uncommon baud rate. Connect to Ch 7 and
move the Navtex sensor to another computer with free channels.
Keep the standard when installing. Stick to the tables as far as it will go.
SINGLE ECDIS900
Monitoring SIS4000-Mk2
GPS1 Ch1, port 8010
GPS2
Gyro Ch2, port 8011
Log Ch3, port 8012
ARPA_X Ch4, port 8013
ARPA_S
Wind Ch5, port 8014
ES Ch6, port 8015
Navtex Ch7, port 8016
AIS Ch8, port 8017
Once the channels are configured, the Sensor Monitor reads the data and transmits it over
the ECDIS network, making it available for all other computers.
For that reason, it is imperative that every sensor in the system has its own unique port
number to avoid conflicts.
To Next Page
Loading...
