MARIS ECDIS900 Installation Manual
SYSTEM OVERVIEW
HARDWARE
MARIS ECDIS systems come in several variants:
Stand-alone unit MARIS ECDIS900 MK15 19” 4S
MARIS ECDIS900 MK15 24” 4S
Split unit MARIS ECDIS900 MK5 and MK5A can be delivered with four different monitors:
• Hatteland 24" monitor
• Hatteland 26" monitor
• Simrad M5024
• Simrad M5027
Both variants have VGA output for a slave monitor that can be used for Conning Display or
installed in the captain’s quarter. The maximum cable length is 15 meters.
The split units are flexible as the monitor size can be selected from 24 to 26 inches. Wide
screen monitors are supported.
More information about the installation possibilities can be found in the chapters, Electrical
and Mechanical Drawings.
The split solution requires a standard RS232 serial cable between the units. This cable carries
control signals for the color table, dimmer and audible alarm.
For configurations using the M5024 monitor, refer to the E0102 Alarm Panel User Guide and
the M5000 Series Monitors User Guide.
The VGA connection is intended for a slave monitor or VDR.
To Next Page
Loading...
