Simrad Maris ECDIS900 - Page 68

Troubleshooting
time
HDD failure
Fan on.
Bios starts
error
system
configuration
window:” Pri.
Master disk
None.
Sec. Master
disk None”.
set up
Check cables
Run HDD
diagnostics
Replace the
HDD.
Ethernet
controller
Network driver
does not
detect network
controller
Network
controller is
disabled
No access to
network
Run computer
set up and
enable
controller
network.
Ethernet
controller
System
software set
up.
Network status
link light does
not turn on or
flashes
N
o active
network is
detected
Network
controller is
not set up
properly
Network driver
is not correctly
loaded
SMonitor
cannot be
launched.
Check cabling
Use the
network
control
application to
verify that
device is
working
properly.
Reinstall
network
drivers
Replace
system board
VIDEO
Equipment
Failure detection
Cause
Effect
Action to fix
Video cable
V1
Black screen
The video cables
are unplugged.
No display
Check cables
seating
Backlight
Front panel
P12 , P16
Black screen
Backlight is
turned down.
On/Off display
button of the
front panel Off.
No display
Adjust the back
light.
Button on.
DATA ACQUISITION
Equipment
Failure detection
Cause
Effect
Action to fix
System set up
Cannot use the 4
serial ports
IRQ conflicts.
Quit ECDIS900.
Launch Windows
NT diagnostic,
open the panel:
“Resources”.
IRQ for serial ports
should be 03,
68