Simrad Maris ECDIS900 - Page 69

Troubleshooting
04,07,08.
If not reboot the
computer, enter
the set up and
change IRQ.
Run the recovery
CD.
Check the board
plug.
Replace the serial
board.
Serial ports.
Serial cables
Sensor output set
up.
S_Monitor
configurations
Monitoring
station: Warning
“GPS – DR alarm”
in ECDIS900
In SMonitor GPS1
data not available
or faulty.
Same for the
second GPS and
planning station
Bad connection
with the GPS
1.
GPS 1 failure.
Bad selected data
format.
The ship’s
position is not
monitored on the
chart.
Check the serial
cable plugged in
the computer and
in the GPS.
Check the wiring
RS232 or 422 …
(See technical
manual).
Open the terminal
window in
SMonitor
and
check the
incoming data
format.
Select another
format (NMEA
or..) ij the
configuration
window of the
serial port
Check the output
configuration of
the GPS.
Click right button
in the GPS
indicator and
select GPS1 as
master.Check the
serial cable
plug
ged in the
computer and in
the GPS.
Check the wiring
RS232 or 422 …
(See technical
manual).
Open the terminal
69