20
Profile
There are many profile-related functions. For custom profiles, see “2.3 Custom Profile.”
Setting
This enables the designation of various setting values needed for slicing.
Printer Setting (DP200/DP102, 3DWOX 1)
-
Printer Model: A connected default printer appears on the screen.
-
Number of Nozzles:
The number of nozzles of the device is displayed
-
Bed Heating Function: Only select when bed heating function is available. When left unchecked, G-code
for bed heating will not be created.
-
Slicing Origin Point Correction (based on the equipment’s origin point): Place the 3D model on the
bed based on the equipment’s origin point (0,0).
-
Origin Correction (Bed center): Automatically controls model to be always positioned in center of printer
bed.
-
Maximum Printing Size: Insert maximum printable size of the connected printer.
-
E-mail: Sends the printing status to the entered e-mail address.
Under “email,” input the recipient email address(es) and select the number of times to send the
notification emails. Additional recipient addresses can be added by using “;.”
ex> recipient1@test.com; recipient2@test.com; recipient3@test.com
The maximum number of notification emails that can be sent is 10.
An email notification, an email will be sent out for the user to see if the email notification is working properly
by default. So the email will be sent out one more time than the number that the user entered. However,
the number of email that is sent will not exceed 10 times.
(When user selects 10 times, the notification email will be sent out 10 times)
To Next Page
Loading...
