Singer 270 - Page 98

FOR MACHINE 29 9U210
KN I FE, C U1'TING D RIVU \G WHE EL, CUTilN G S TARTIN G LE VE R TlU P CAJU{I I: R
N
EE D LE TH READ CONTRO LL ER CAN, P ATI ERN WHE E l. C AJ. I BLO CKS
Ref. Part
No. No.
-- -
1 548 664
2 548663
3
54 52 64
4 548832
5
549013
6 54 8428
7 504056
8 548672
9 548383
10 548670
11
548622
12 548671
13
54 90 12
14 5 48 668
15 548669
16 549 0 11
17 548666
18 ** 548983
19 **548801
20
**548984
21
** 548394
22
**548978
25
**548389
··-
(804)
(805)
(830)
(8 05)
(8 0S)
ll esc r ip ti on
Butt onh ole <llttin g D riv ing Wheel
Buttonhole C utt ing Drivi ng lfueel 548664 with 545232 (830),
545240 (805), 548059 t o 54806 2, two each 545241 (80 3),
545 242 (805) and 548063
Buttonh ole Cutt i ng Safety Le ver Latch Spring Eyelet {2)
Needle Thread
Controller CJm w ith two 549098 (850)
Needle
Vibrating Adjusti ng Stud Stop Screw
Pattern Wheel S haft Co llar with two 504056 (830)
Pa t tern Wheel Sh aft Colla r Set Screw (2)
Buttonhole
Cutt ing Starting Lever Tr ip Plate Carrier Hand
Trip
Buttonhole Cut ting Startin5 Lever Trip Plate Carrier Hand
Tri p P in
Buttonho le Cutting Starting Lever Trip Plate Carrie r
Buttonh ole Cutting Starting Lever Trip Plate Ca rrier Hand
Tri p Spring
Butt onhole <lltting Starting Lever Trip Plate Carrier Stud
Bu ttonhole Cutting Starting Lever Trip Plate Carrier Stud
Screw
Buttonhole Cutt ing Starting Le ver Pla t e
Buttonhole
Cutting Starting Lever Plate Extension
Buttonhole Cutting Starting Lever Plate Extension Screw (2)
Buttonhole
Cutting Lever (lower) Cam wi th 504028 (85 0)
Pattern Wheel Cam Block (1st side) (1 /4" max.) complete, Nos.
548391,
548801, 549191 and t wo 545133
Pattern l!heel Clllll Block (1st side)
Pattern \o,heel Cam Block (2nd side) (1/1'' llax .) complete, No s.
545138, 545332, 548391 , 548394 , 548396 a nu 5 491 91
Pa ttern Wh e el (.am !!lock (2nd side)
Pattern Wheel Cam Block (eye) (.140 x .1 90) 548389 w it h
548391, 548492
and two 54~191
Pattern "heel Cam Block (eye) (.140 x .1 90)
-114 -