Singer 9134 - Using the Needle Threader

USING THE NEEDLE THREADER (P)
To help in threading the machine needle, use the needle threader a_s follows:
o
o
Thread machine and draw 4" (10 cm)
of thread down to the needle.
Lower presser foot lifter,
Holding needle threader as shown with
your right hand, position U-shaped part
of threader under bar of needle clamp.
Snap threader up onto bar.
-- : IIIIII1'11111111IIIII lUJlJ "J
° Swing threader back just far enough to
clear the needle.
• Slide threader as far to the left as it will
go.
• Be sure guide (1) is against the left side
of the needle.
° Bring metal hook of threader forward,
through the eye of the needler
° Holding 3" (7..5 cm) of thread between
your fingers, guide thread into metal
hook. Release thread.
12
Holding threader with right hand, draw
metal hook and thread backwards
through eye of the needle.,
o To remove needJe threader, slide it to
the right, and off bar of needle clamp,
° Carefully unhook thread from needle
threader,