WINDING A BOBBIN
Winding a bobbin is quick and easy when you follow the directions below. Always wind the
bobbin before threading the machine.
,, Push in indent (1) on hand wheel disc. This will stop the needle from moving.
This step is not necessary if your machine does not have hand wheel disc.
- Place spool of thread on spool pin.
- Slide spool cap (2) firmly over rim of spool to prevent thread tangling.
,, Lead thread from spool and snap into thread guide post (3)°
o Wind thread clockwise around front of bobbin winder tension disc (4).
° Pass thread end, from inside, through small hole in rim of bobbin+
° Place bobbin on spindle and push it to the right, On machines without hand wheel
disc, this will automatically stop needle from moving.
o Holding thread end, step on speed controller to run machine until desired amount
of thread is wound. (Winding stops automatically once bobbin is full.)
,, Cut thread; push bobbin to the left and remove it from spindle.
- Trim thread end from top of bobbin.
• Return hand wheel disc to sewing position by pressing on side opposite indent.,
1
_ ttm
14
To Next Page
Loading...
