4
SKF TKBA 40
Safety recommendations
• Always turn off the power of the drive machine before you
start working.
• Always read and follow the operating instructions.
• Although the laser diode in the laser unit has an output power of
less than 1 mW, never stare directly into the laser transmitter.
• Never aim the laser beam into another person’s eyes.
• Opening the housing of the laser unit may result in hazardous light
exposure and voids the warranty.
• Take care not to pinch your fingers when mounting the units on
the pulley.
• The equipment should not be used in areas where there is a
risk of explosion.
• Never expose the equipment to high humidity or direct contact
with water.
• Have all repair work performed by an SKF repair shop.
To Next Page
Loading...
