- flat battery / - current-emitting battery
1
pole of the flat battery
2
pole of the current-emitting battery
3
pole of the current-emitting battery
4
Earth point of the engine to be started
Start the engine
›
Start the engine of the current-giving vehicle and
let it idle.
›
Start the engine of the vehicle with the flat battery.
›
If the engine of the vehicle with the flat battery
does not start within 10 seconds, repeat the start-
ing procedure after approximately 30 seconds.
Disconnecting the cable
›
Disconnect the cables in the reverse order from
connection.
Fuses
What you should be mindful of
NOTICE
Fire hazard and risk of damage to the electrical sys-
tem.
▶
Do not repair fuses or replace them with stronger
fuses.
▶
Replace the defective fuse with a new fuse with
the same amperage.
▶
We recommend using replacement fuses from the
ŠKODA Genuine Accessories range. These guaran-
tee reliable and safe consumer protection.
▶
If a newly inserted fuse blows again, seek the help
of a specialist garage.
Earth point
One fuse may belong to several consumers. One
consumer may have several fuses.
Functionality
Blown fuse
Conditions for the replacing a fuse
✓ Ignition key removed (vehicle without starter
button).
✓ Ignition switched o and driver's door open (vehi-
cle with starter button).
✓ All consumers switched o.
Replacing a fuse
›
Replace the fuse with
the clamp located on
the inside of the fuse
box cover in the engine
compartment.
›
Use the appropriate
end of the clamp ac-
cording to the fuse di-
mensions.
Fuses in the dash panel
Overview
Access to the fuses
›
Open the storage compartment on the driver's
side.
›
Press the button and
open the tray.
›
Pull the tray out by
pulling it towards you.
›
Change the fuse.
›
Insert and close the
tray at the original lo-
cation.
150
Vehicle battery and fuses › Fuses
To Next Page
Loading...
